SR-1800
Precautions for Use
Handle the device with the following points in mind to enable full use of its functions.
Precautions regarding installation
Do not place the device in the following places. Otherwise, failures could result such as sheet
jams, reading errors, or the unit could stop operating.
(1) In direct sunlight or near a heating device.
(2) Outdoors where the main body may not perform satisfactorily due to rain or strong wind.
(3) Places where the machine may not perform satisfactorily, such as unstable or inclined
surfaces, or other locations where the machine may shake while it is operating.
(4) Places subject to sudden temperature changes, excessive moisture and dust.
Recommended temperature: 10 - 30°C (50°F - 86°F)
Guaranteed operating temperature range: 5 - 35°C (41°F - 95°F)
Humidity: 30-80% (no condensation)
Avoid environments outside the above ranges as much as possible.
Handling precautions
(1) Do not connect or disconnect the power plug or DC plug of AC adapter when the device is
in operation or the power switch is on.
(2) Do not move the device while it is operating. Also, do not touch, pull, or push the sheet.
(3) Do not put objects on the device, or sit or lean on it.
(4) Do not give the device a strong vibration and shock etc.
(5) Allow an interval of at least 5 seconds between turning the power switch on and off.
(6) Do not insert foreign objects other than the sheet.
(7) Do not apply force that deforms the sheet while it is being loaded.
(8) Since the sheet reader is equipped with an optical lens, never insert a screwdriver or other
such objects. (Otherwise, reading may be disabled.)
If sheet feeding is disabled due to dust or the like in the sheet feeder, open the top cover to
remove it. See “Cleaning” (P.39).
(9) If the roller becomes soiled with powder from sheets or pencil lead, the roller and the sheet
may slip. In order to prevent slippage, clean the roller at proper intervals. See "Cleaning"
(P.39).
(10) If the exterior of the device is soiled, lightly wipe with a soft cloth wetted with water or a
neutral detergent. Note that wiping with a cloth wetted with volatile chemicals like benzene
or paint thinner may cause deformation or discoloring.
(11)
Do not place excessive load on the sheet feed tray and stacker. Doing so may result in
deformation or damage.
(12) When the machine is not used for a prolonged period of time, remove the power cord from
the outlet.
(13) When the machine is not used for a prolonged period of time, keep the hopper set in the
down position.
