SR-1800
Marking Instructions
Marks readable by this device are as follows.
(1) Mark size: 0.5 × 3mm or more (recommended mark)
(2) Readable writing instruments: pencils (black, HB or darker), [Option: ballpoint pens (black or
blue)]
(3) Readable marks: Filled-in spaces,
●
CAUTION
●
must have a filled-in area of at least 0.5mm × 3mm (recommended mark size)
(4) Readable mark darkness: PCS 0.6 or darker
Readable mark darkness can be adjusted.
You can check mark darkness using a diagnostic utility included in the package, so check
the darkness of the marks you want to read and adjust the reading setting on the computer
side.
REFERENCE: ”About Reading Sensitivity Level” (P.26)
CAUTION
When using a pencil or mechanical pencil, make sure to mark with adequate darkness.
About Reading Sensitivity Level
When this device is operating in the SR-600 mode, it is possible to set the reading sensitivity level
with a command from a computer.
The reading sensitivity level ranges from 1 through 16, with Level 1 having the maximum reading
sensitivity and Level 16 having the minimum reading sensitivity.
The table below compares the reading sensitivity levels of this SR-1800 device with the
conventional SR-600 device.
Comparison Table of SR-1800 and SR-600 Reading Sensitivity Level Approximate Values:
SR-1800
Sensitivity Level
SR-600
Sensitivity Level
SR-1800
Sensitivity Level
SR-600
Sensitivity Level
SR-1800
Sensitivity Level
SR-600
Sensitivity Level
1
1
7
5 to 6
12
10 to 11
2
1 to 2
8
6 to 7
133
10 to 11
3
2 to 3
9
7 to 8
14
11 to 12
4
3 to 4
10
8 to 9
15
12 to 13
5
4 to 5
11
9 to 10
16
13 to 14
6
5 to 6
*1: The above sensitivity levels are the approximate values for marks filled in using SEKONIC
Corporation measurement methods.
*2: Both devices have different reading methods, so there are differences in levels depending on the mark.
*3: If SW3-1 and -2 are set to “SR600MODE” and used in the compatible mode, sensitivity levels
must be checked by the user.
