Chapter 2
Getting Started
User Guide
2-7
Loading a Roll of Labels
Follow the instructions below to load a roll of standard
address labels. Instructions on loading other label types
appear in Chapter 3.
Prepare the roll of labels
1 Remove the sticker from the beginning of the roll of
labels.
Note...
Check to be sure there is a black sensor mark on
the label backing as illustrated on page 2-3.
2 If needed, cut between the labels to create a “leader.”
If the end of the roll is not prepared as shown above, cut
between the labels leaving as much backing as possible
on the end of the roll to act as a leader.
Load the roll of labels
1 Make sure the power cord is connected and the printer is
turned on.
The green status light should be flashing.
2 Lift the base of the clear plastic label cover and rotate it
open.
Roll
Prepared end
Cut here
Roll
Waste
Spindle
Label
cover
slp120-2.bk Page 7 Friday, March 3, 2000 12:40 PM
Summary of Contents for SLP120
