Basic Rider Optimization Training for the Segway
HT
Page 71 of 106
Instructor Guide and Participant Workbook
Rev 3.5i - January 2004
© Segway LLC 2002
P/N 1707100001aa
Charging Failures
If a failure is detected during charging, all charging will stop. Depending on the nature of the failure, a
solid red charging indicator light will be displayed or the charging indicator will be off.
If either or both charging indicators are off or red, do this:
>
If the charging indicators are off (no illumination), check to make sure that AC power is present.
>
If AC power is present and the charging indicators are either red or off, disconnect from AC
power, then remove and reseat the Battery Pack(s), following the instructions on page 75.
>
If this does not resolve the problem, contact Segway Customer Operations at 1-866-4SEGWAY
(1-866-473-4929).
Before Each Ride—Remember to Close the Charge Port Cover
Close the Charge Port Cover except when you are charging the Segway HT. Closing the Charge Port
Cover will prevent water, dirt, dust, and other contaminates from entering through the Charge Port
and causing damage to your Segway HT.
Battery Charge Level Display
The dashed ring around the perimeter of the Display indicates the battery charge level. The following
series of displays illustrates a gradually depleting battery charge while in Balance Mode:
Full
charge
Low
charge
This series of displays illustrates the same battery charge levels while in Power Assist Mode:
Full
charge
Low
charge
The Segway HT will display intermediate battery charge levels using flashing segments (e.g., a
battery at approximately 90 percent will display a flashing top bar).
If the battery charge level is very low, the Segway HT will notify you of a pending empty battery
condition prior to initiating Safety Shutdown (see page 58).