TOWER
AND BILLBOARD TEST MODE
By turning the tower control board’s DIP SW 2 to ON, you can conduct tests of the control tower and billboard when
turning on product’s power.
DIPSW
□■□□□□□□
■□■■■■■■
1 2 3 4 5 6 7 8
FIG. 4-2a
Flipping the switch on the control tower’s service panel allows you to conduct the checks below.
FIG. 4-2b Service Panel
• Main switch
When OFF, any input from the switches is cancelled, so nothing will happen even if other switches are pressed.
Check that this is ON when in Test Mode.
• ENTRY button
Each ENTRY button will illuminate when pressed.
The ranking board’s LED display on the billboard will change to match the ENTRY button that has been pressed.
The color of the car display on the ranking board will change whenever the button is pressed, and, finally, the LED
display that responded will extinguish.
Ranking Board
1st
Car Picture Arrow ←Will illuminate when ENTRY button 1 is pressed.
2nd Car Picture Arrow ←Will illuminate when ENTRY button 2 is pressed.
3rd Car Picture Arrow ←Will illuminate when ENTRY button 3 is pressed.
4th Car Picture Arrow ←Will illuminate when ENTRY button 4 is pressed.
• CAMERA selector button
The CAMERA selector buttons will illuminate while pressed.
The CCD camera video feed corresponding to the cabinet number whose button was pressed will be displayed on
the LCD monitor.
• MOTION selector switch
The corresponding safety lamp will illuminate when each switch is set to STOP (up), and the corresponding error
lamp will illuminate when each switch is set to MOVE (down).
- TOWER AND BILLBOARD TEST MODE
