0
PRECAUTIONS REGARDING PRODUCT OPERA
TION
(4)
CAMERA selector button
These buttons enable any desired CCD camera image to be selected. The CCD camera video from the illuminated
button’s corresponding seat is displayed on the billboard’s LCD screen. The video of the ride whose video you want
to be displayed on the LCD screen will be displayed on the LCD screen while the seat’s corresponding button is
pressed.
(5)
SAFETY lamp
While this lamp is lit, the motion operation of the ride is enabled. When the lamp is out, the ride is in a stopped
condition.
Lit:
Motion takes place normally.
Out:
The motion selector switch on the tower side is in the STOP position.
Blinking: The motion stop switch on the ride side has been pressed.
(6)
ERROR lamp
Starts blinking when an error has occurred. The error status will be shown by the button’s illumination.
Out:
Communicating normally.
Blinking: There is an abnormality in the communications of the tower control board and actuator control board.
(7)
MOTION selector switch
This switch allows changing between STOP and NORMAL for the in-game motion. However, the ride will not move
until the game is over if the switch is set to STOP when the game starts.
(8)
Microphone volume control (MIC VOLUME)
This is for adjusting the volume of the microphone used by the attendant for announcements.
OPERATION MODE Settings
Attendant operation of the control tower is affected by each setting as shown below.
TABLE 1-3
OPERATION
MODE
Operation of
control tower
Work procedure
Operation 1
Entry method
Operation 2
Game start
method
Operation 3
Selection of
number of drivers
TICKET 1
Yes:
Entry and game
start operations
can be performed
from the control
tower, and any
incorrect input,
which was made
when deciding the
number of drivers,
can be canceled,
and a selection
made once again.
Press the
ENTRY button
corresponding
to the cabinets
that you wish
to enter into a
game.
Upon
completion of
the entry, press
the START
button.
Once the players have determined the
number of drivers, the screen pauses
temporarily, and the machine waits for
input from the attendant. Provided that
there is no problem with the selection, the
attendant should briefly press the ENTRY
button of the desired cabinets. Then, the
next selection screen appears.
If a mistake was made in the selection
of the number of drivers, pressing the
ENTRY button of the desired cabinets for
an extended period (at least 3 seconds)
will cause the previous screen to reappear.
TICKET 2
Yes:
Entry and game
start operations can
be performed from
the control tower.
Press the
ENTRY button
corresponding
to the cabinets
that you wish
to enter into a
game.
Upon
completion of
entry, press the
START button.
This completes
the work of the
attendant.
No
COIN
No
No
No
No
