[Table of Contents]
[Previous Page]
[Next Page]
PROJECTOR ADJUSTMENTS
CAUTION!
Since the projector has been adjusted at the time of shipment, do not make any further
adjustments without good reason.
Fine adjustments are stored in the projector. Pressing the fine adjustment switch (Convergence
adjustment) results in entering the fine adjustments mode, and this may cause the stored fine adjustment
to be changed. During work other than for adjustment, should you touch the fine adjustment switch by
mistake, immediately turn off power by using the main switch and then turn it back on again. If any
distortion or color deviation is found in the test mode, and adjustments are needed, use the specified
adjustment knob or perform the adjustments by using the remote control. Note that projector models and
makes may vary, and adjustment methods will differ dependent on the manufacturer.
STOP: IMPORTANT!
The projector is subject to color deviation due to convergence deviation caused
by geomagnetism at the installation location and peripheral magnetic field. After the installation of
machine, and before commencing operation, check for convergence deviation and, if deviated, make
necessary adjustments.
CLEANING THE SCREEN
CAUTION!
Since the projector screen is highly susceptible to damage, pay careful attention to its
handling. When cleaning, refrain from using water or volatile chemicals.
When the screen surface becomes dirty with dust, etc, clean it using a soft cloth such as gauze. When
water and volatile chemicals such as benzene, thinner, etc, spill onto the the screen surface, it may be
susceptible to damage, therefore, refrain from exposing the surface to these liquids. Also, since the
screen surfaces are easily susceptible to damage from abrasion, avoid rubbing them with any hard
materials or using a duster.
Page 1 of 1
Projector Adjustment
7/12/2005
http://www.sauservice.com/manuals/Gunblade%20Folder/GB42.html
