[Table of Contents]
[Previous Page]
[Next Page]
REPLACEMENT OF TRIGGER SW
WARNING!
In order to prevent an electric shock and short circuit be sure to turn off power before performing work
which involves touching the interior of the product.
Be careful so as not to damage wiring. Damaged wiring can cause an electric shock or short circuit
accident.
When the trigger is pulled, if ON is not shown in the trigger display in then test menu input test screen,
the micro sw may be malfunctioning. In that case it is necessary to replace the micro sw.
REMOVING THE GRIP
Take off 7 tamperproof screws A and cover right.
Take off 5 tamperproof screws A and remove the cover left with cover bracket attached to it. Pay
attention to the wires attached to the bracket so that they are not damaged.
Disconnect the connector which is connected to the grip.
Remove 6 U nuts to remove the grip.
Page 1 of 1
Trigger Switch
7/12/2005
http://www.sauservice.com/manuals/Gunblade%20Folder/GB37.html
