Rostock Max Assembly Guide
54
19 – Installing the Limit Switches and Adjustment Screws
19.1 - First, install three adjustment screws, #6-32, 2" as shown on each of the three U-Joint
carriers. Thread the screw about 3/8" deep.
Figure 85 - End Stop Adjustment Screw
19.2 - Next, the three wiring harnesses (2 wires) for the limit switches need to be routed. Gently
twist the wires together at the end with the little brass crimp on connectors.
19.3 - Get some fishing line or dental floss. You'll use this to pull the wiring down the
inside of the rail. The reason for this is that due to the angle of entry, the wire isn't stiff enough
for you to be able to push it down the channel. You'll save yourself a lot of grief by pulling with
fishing line. (You'll eventually go mad and throw the machine through your living room window.
Then much Scotch ensues. It's not pretty.)
19.4 -Before you thread the wire down the rail, route it through the wire slot that's right in front
of the Idler Bracket as shown:
Figure 86 - Top End Stop Wire Slot
