2
|
INTERNATIONAL
QUICK GUIDE
Step 1
SAFETY
Read & understand the safety section.
Step 7
SECURE DROPPER &
TRANSITION
Use the TEK screws provided. Break the
transport clips for the AutoWinterseal.
Step 14
INSTALL INLET SOLENOID
Use the supplied hose set and fittings.
Note the water flow direction marking on
the solenoid.
Step 20
SET THE WATER LEVEL
Turn on the mains water and adjust the
float to allow water to fill to the required
level.
Step 21
COMMISSIONING THE COOLER
Switch the mains power on and test run
the cooler.
Step 2
COOLER LOCATION
Check cooler location. Consider
regulations. Discuss with customer.
Step 8
CHECK AutoWinterseal™
Check operation of the AutoWinterseal.
Ensure AutoWinterseal moves freely.
Step 15
INSTALL DRAIN VALVE
Never drain waste water directly onto the
roof. Be sure to use supplied ‘O’ Rings
and fittings.
Step 3
REMOVE VENTURI
Press the clip or remove the screws on
both sides of the venturi to release.
Step 9
CONVEY COOLER TO ROOF
Page 1
Page 8
Page 9
Page 4
Page 6
Page 10
Page 13
Page 6
Page 14
Page 4
Always use 2 persons to position the
cooler when handling manually.
Step 19
MOUNT AND CONNECT THE
CONTROLLER
Page 12
CPQ/LCQ/LCS
BMQ
LCQI
Step 13
INSTALL FLOAT VALVE
Assemble the float valve to the cooler.
Ensure all washers and o-rings are in
place. No thread tape is required.
Page 9
