4
|
INTERNATIONAL
CPQ/LCQ/LCS
TBQ/TBS
BMQ
LCQI/TBQI/TBSI
COOLER LOCATION
Check proposed cooler location to ensure it is structurally
capable of supporting the weight of the cooler. If the roof is
structurally inadequate, provide an alternate load bearing
structure.
The ideal location for the cooler is in a central position on the
roof (away from sleeping areas and where people spend most
of their time) so that the duct runs are of approximately the
same length. Carefully consider neighbouring residences and
noise levels when locating the cooler, if necessary talk to the
customer and the neighbour before carrying out the installation.
Always locate the cooler where it will receive adequate fresh air
and not in a recess where it may be starved for air or where the
air is polluted.
Ensure location is a minimum of:
•
3m (10’) from a solid fuel heater flue,
•
1.5m (5’) from a gas flue,
•
5m (17’) from a sewer vent, and
•
600mm (2’) from a wall.
ILL1150-B
ILL2111-B
ILL1155-C
REMOVING THE VENTURI
Once the pad frames have been removed, detach the
venturi / fan assembly and the electronics module.
For LCQ/LCS/TBQ/TBS & CPQ models, disengage the two
venturi clips as shown. For LCQI/TBQI/TBSI & BMQ models,
remove the 2 screws securing the venturi to the tank.
X
ILL1150-B
REMOVING THE TRANSITION
•
The cooler must be mounted at least 3m (10’), preferably
5m (17’), away from any TV antenna or antenna cables.
Make sure the cooler is not between the antenna and the
transmission tower that is providing the television signal to the
home.
Allow adequate access to and around the cooler for
maintenance. Provision must be made for access to electricity,
water supplies and drains.
Note!
Do you need to discuss the installation of items like
safety anchor points with the customer?
Disconnect the electronics module from the tank by removing
the screw under the switch. The isolation switch cannot be
activated with this screw removed. Remove the pump and motor
cables from the plugs in the electronics module.
Note!
Place the electronics module and the screw safely to
one side for later use. Do not re-fit the electronics module, as
the motor plug will require connection to the underside of the
module when the venturi is refitted into the cooler.
Lift the venturi and fan assembly out of the cooler, taking care of
the motor lead(s).
The venturi and fan assembly can be placed on to the ground
until the rest of the cooler has been installed on the dropper.
Turn the cooler onto its side to remove the transition.
There are clips in each of the four corners that will disengage
once the transition is given a firm pull.
If any of the corners are difficult to remove, do not use
excessive force. Gently squeeze the clips together and remove
the transition one corner at a time.
ILL1053-C
REMOVING THE VENTURI
cont
