Manual ISDN Adapter- Startup/Software Installation for Windows NT 4.0 77
Note (see figure 9.4.3.1.3)
Term
Explanation
DOS-CAPI-Interrupt
The DOS-CAPI-Interrupt, a Software-Interrupt controls the
communication between the DOS-application and the Windows-
CAPI. Special applications can expect a different value. Valid
values are for example F1 or F2 (in hex).
Data I/O Mode
Data of other drivers or applications can be stored temporarily
i.e. an overwriting before handling is not possible.
V.42bis data compression
Activate by application:
Disabled:
Activated with X.75/V.120:
V.42bis is a standard compression in telecommunication. In
June 1998 the specification for the CAPI 2.0-implementation of
V.42bis was changed. Unfortunately the two versions are not
compatible. The drivers for the Sedlbauer ISDN-adapter use the
new standard as default setting from driver version 2.2 rev. 0.5.
Only applications requiring a V.42bis extended protocol via
CAPI can get a connection to V.42bis if the opposite terminal is
compatible.
The controller behaves as if no V.42bis would be available.
All applications using the X.75 and V.120 protocols under CAPI
V2.0 get connection to V.42bis when the opposite terminal is
compatible.
X.75/V.42bis Start mode:
Start in uncompressed Mode:
Start in compressed Mode:
Corresponds to the standard from 7. June 1998
Corresponds to the standard until 7. June 1998
X.75/V.42bis Flush mode:
Standard flushing Modus:
Special flushing Modus:
Corresponds to the standard from 7. June 1998
Corresponds to the standard until 7. June 1998
Register card „Info“:
The register card „
Info
“ contains besides data regarding copyright, program and the address of the producer
the opportunity to check the directory & version of the drivers.
When you click „
driver versions
“ a short list of all drivers installed or to be installed appears.
Register card „Options“
The register card „
Options
“ enables you to choose the language. In addition, the initial settings of the driver
can be re-established with the button <
Set Default…
>.
After you confirmed this configuration with <
OK
> you will be asked for restart. Confirm with <
Yes
> to take
over these amendments in the system.
Your ISDN-Adapter is ready for use after Windows NT4.0 is restarted
!
