Security Brands Edge 27-210, Direct Programming Manual

Page: 65 / 80

Edge
Smart Keypads and Card Readers Direct Programming Manual

If you need help, please email techsupport@securitybrandsinc.com or call (972) 474-6390 .
61
Enter next sub mode 3 and listen for good tone.
Enter 3-digit facility code and listen for good tone.
Enter 5-digit starting code and listen for good tone.
Enter 5-digit ending code and listen for good tone (maximum of 100 codes).
Enter # key to exit Programming Mode.
Note: This procedure will not work if any of the following are true:

Wiegand input is set to SBI Flex 64-bit format.

Wiegand input is disabled.

Wiegand input is configured to share code list with non-Wiegand codes.

Split relay feature is enabled.
Scan Entry for Wiegand Card Readers and Vehicle Tag Readers
This procedure will delete one or more codes with a specified facility code by scanning for a
Wiegand card reader or vehicle tag reader.
1251
$
6
$
1
$
200
$
4
$
Scan First Card
$
...
$
Scan Last Card
$
#
Enter Master Code (default 1251) and listen for good tone.
Enter sub mode 6 and listen for good tone.
Enter 1 (for Wiegand Input 1). No tone will sound.
Enter next sub mode 200 and listen for good tone.
Enter next sub mode 4 and listen for good tone.
Scan card to be deleted twice at reader and listen for good tone.
Repeat above step to add additional codes.
Note: Card-to-card swipe timeout is 10 seconds.
Enter # key to exit Programming Mode.
Note: This procedure will not work if any of the following are true:

Wiegand input is set to SBI Flex 64-bit format.

Wiegand input is disabled.

Wiegand input is configured to share code list with non-Wiegand codes.

Split relay feature is enabled.
Delete Code(s) on Wiegand Input 2
These procedures will delete codes for Wiegand keypads, card readers, remotes, and vehicle tag
readers on Wiegand Input 2 only.