Direct Programming Manual
Edge
Smart Keypads and Card Readers
12
If you need help, please email
or call
(972) 474-6390
.
(The default configuration is Relay B trigger.)
1251
$
4
$
9
$
5
$
X
$
X
$
#
Enter Master Code (default 1251) and listen for good tone.
Enter sub mode 4 and listen for good tone.
Enter secondary sub mode 9 and listen for status tones:
Good tone:
Event Input 1 is disabled (Mode 0).
One tone:
Mode 1 enabled.
Two tones:
Mode 2 enabled.
Three tones: Mode 3 enabled.
Four tones:
Mode 4 enabled.
Five tones:
Mode 5 enabled.
Enter 5 for Mode 5 and listen for good tone.
Enter 1 (for relay selection) or 2 (for relay operation selection) and listen for good tone.
Relay Selection:
Enter 0 (for Relay A) or 1 (for Relay B) and listen for good tone.
Relay Operation Selection:
Enter 0 (for trigger) and 1 (for latch) and listen for good tone.
Enter # key to exit Programming Mode.
Add Latch Code to Relay A
This procedure will add a latch code to Relay A.
Note: By default, the following codes are reserved for other functions and cannot be used:
1251, 1273, 1366, 1381, 1387, 1678, 1752, and 1985.
1251
$
5
$
XXXX
$
#
Enter Master Code (default 1251) and listen for good tone.
Enter sub mode 5 and listen for good tone.
Enter code (4 digits by default; numbers only) to be added and listen for good tone.
Enter # key to exit Programming Mode.
Add Access Code(s) to Relay A on Both Wiegand Inputs
These procedures will add an access code or codes to Relay A for Wiegand keypads, card readers,
remotes, and vehicle tag readers on both Wiegand inputs.
Quick Entry for Wiegand Keypad (uses default facility code)
This procedure will add one or more access codes with the default facility code for a Wiegand
keypad. Both the 26-bit and SBI Flex 64-bit formats can be used.
1251
$
6
$
100
$
1
$
XXXXX
$
#
Enter Master Code (default 1251) and listen for good tone.
