Seat Ateca 2020, Owner'S Manual

Page: 122 / 376

Operation
Several warning and control lamps light up
for a few seconds when the ignition is switch-
ed on, signalling that the function is being
verified. They will switch off after a few sec-
onds.
WARNING
Observe the safety warnings
›››
in Con-
trol and warning lamps on page 90 .
Headlight switch
Fig. 107
Dash panel: lights control.
●
Turn the switch to the required position
›››
Fig. 107 .
Sym-
bol
Ignition switch-
ed off
Ignition is
switched on

Fog lights, dipped
beam and side
lights off.
Daylight running
lights switched on.
Sym-
bol
Ignition switch-
ed off
Ignition is
switched on

The “Coming
home”, “Leaving
home” and Wel-
come lights may be
switched on.
Automatic control
of dipped beam
and daytime run-
ning light.

Side light on.
Daylight running
lights switched on.

Dipped beam head-
light off
Dipped beam
switched on.
The driver is personally responsible for the
correct use and adjustment of the lights in all
situations.
Automatic dipped beam headlight control

*
The automatic dipped beam control is merely
intended as an aid and is not able to recog-
nise all driving situations.
When the light switch is in position

, the
vehicle lights and the instrument panel and
switch lighting switch on automatically in the
following situations
›››
:
●
The photo sensor detects darkness , for ex-
ample, when driving through a tunnel. They
switch off when adequate lighting is detec-
ted.
● The rain sensor detects rain and activates
the wipers. They switch off when the wipers
have not been activated for a few minutes.
Daytime running lights
The daytime running lights consist of individu-
al lights, integrated in the front headlights.
These lights come on when the daytime run-
ning lights are switched on. On vehicles
equipped with LED tail lights, the rear side
light is switched on as well
›››
.
The daytime running lights turn on every time
the ignition is switched on, if the switch is in
position

or

, according to the level of ex-
terior lighting.
When the light switch is in position

, a light
sensor automatically switches dipped beam
on and off (including the control and instru-
ment lighting) or the daytime running lights
depending on the level of exterior lighting.
Motorway light*
The motorway light is available on vehicles
equipped with full-LED lights.
The function is connected and disconnected
via the corresponding Infotainment system
menu.
●
Activation: when going above 110 km/h
(68 mph) for more than 10 seconds, the dip-
ped beam raises slightly to increase the driv-
er's visibility distance.
120