10
ASSEMBLY
Install the winch control switch
STEP 3:
INSTALLATION OF THE WINCH CONTROL
SWITCH
Install the relay (item 1).
#
Item
Description
Action
1
Relay
Install in an appropriate
area.
2
Metal screw
#12 x 3/4’’ (qty 4)
Secure relay in place.
*3
Nylon tie wrap 8’’
(qty 4)
See
*
*If necessary use the nylon tie wraps to secure the
relay in place.
** Install in a sheltered place away from bad weather.
Install the relay
IMPORTANT
To prolong the winch cable’s life, release the winch control switch as soon as the accessory touches the
ground. This will keep the cable from tangling up which causes premature wear.
Before drilling the hole, check behind the dashboard
to make sure there is enough space to install the
switch.
Drill a 1/2’’ hole in the dashboard or an appropriate
place (see reference drawing). Stick the UP/DOWN
decal over the hole for the switch.
Insert the switch in the hole and secure in place with
the rubber boot.
NOTE:
It is important to install the switch vertically.
Connect the wires as shown.
When the switch is raised, the winch must lift the
accessory. If you prefer the contrary, invert the green
and black wires.
Connect the wires
Up / Down decal
