20
OPERATION
SNOWBLOWER OPERATION
a) Make sure the snowblower is clear of snow
before engaging the snowblower.
b) Make sure that the auger and impeller operate
freely.
c) Start the tractor engine.
d) Before engaging the snowblower drive, always
have the engine running at medium R.P.M.
e)
When removing snow, do not use the snowblower
as a dozer blade to push snow. Allow snowblower
to ingest snow at its own speed. If the speed of
your tractor is too fast, the snowblower may
become overloaded and plug.
IMPORTANT: USE FULL ENGINE R.P.M. WHEN
REMOVING WET OR STICKY SNOW. LOW R.P.M.
WILL TEND TO PLUG THE CHUTE.
WARNING
Read the tractor Owner’s Manual carefully. Be
thoroughly familiar with the controls & proper
use of the attachment. Know how to stop the
attachment quickly
.
CONTROLS
CHUTE ROTATION
The chute rotation handle is located to the left of
steering wheel. Turning the handle in a clockwise
direction, the discharge chute will turn in a clockwise
direction or vice versa.
CHUTE DEFLECTOR
Set the angle of the deflector according to the distance
the snow must be thrown. To change the deflector
angle, loosen the two deflector knobs & adjust the
deflector to the appropriate angle.
WARNING
TO PREVENT INJURIES AND FOR MORE
TRACTION WHEN USING AN ATTACHMENT:
-Rear counterweight of 100 lbs. minimum is
required to counterbalance the attachment’s
weight.
-Manufacturer approved tire chains are required.
-Do not operate on a slope greater than 10°.
-When dismounting the attachment remove rear
counterweights.
-Ear muffs and safety glasses are recommended.
IMPORTANT:
THE WINCH KIT IS TO BE USED ONLY TO LIFT
THE ACCESSORY, ANY OTHER USE MAY CAUSE
DAMAGE TO THE VEHICLE.
IMPORTANT:
In order to avoid damage to the battery of the
vehicle, always start the engine before using the
winch
.
Push up or down the winch control switch to lift or
lower the accessory to the ground.
There is a limit switch stopper that limits the lifting.
Always prestretch cable and respool under load
before installing the hook on the accessory. A tightly
wound cable reduces chances of binding, which can
cause damage to the cable.
To prolong the winch cable’s life, release the winch
control switch as soon as the accessory touches the
ground. This will keep the cable from tangling up,
causing premature wear of the cable.
DANGER
Hand contact with the rotating impeller inside the
discharge chute is the most common cause of
injury associated with snowblowers. Never use
your hand to clean out the discharge chute.
-Do not attempt to clear plugged chute, auger or
fan of snow while the snowblower's engine is
running.
-Disengage snowblower.
-Lower snowblower to the ground and set
parking brake.
-SHUT THE ENGINE OFF & REMOVE KEY!
-Wait 10 seconds to be sure that all moving parts
such as the impeller blades have stopped
moving.
-Disconnect wire from the spark plug(s) and keep
wire away to prevent accidental starting.
-Do not use hand to unplug chute use a clean-out
tool (chute shovel).
CLEARING A CLOGGED DISCHARGE
CHUTE:
VERIFY TIRE PRESSURE:
Tire pressure must be even on both sides of the
tractor according to the owner’s manual of the
vehicle.
SNOW REMOVAL
When removing snow, do not use the snowblower as
a dozer blade to push snow. Allow snowblower to
ingest snow at its own speed. If the speed of your
tractor is too fast, the snowblower may become
overloaded and plug. For best results, raise the
snowblower and remove a top layer of snow. A
second pass with the snowblower will remove the
remaining snow.
