8
JDL V1.0 8 2022
Connect the refrigeration harnesses to the two connectors found in the snack unit that are tied together, see
Figure 2 below. (Note: the single harness located inside the snack unit is for the LED lighting which will be
covered in following steps).
Connect the Beverage Main harness to the bottom port on the electrical panel as shown in Figure 3 below.
Figure 2-
Refrigeration
Harnesses
Connected
Figure 3-
Beverage
main harness
attaches to bottom
connector port
MENUS Button
The Beverage Unit utilizes a Drop Sensor that works on shock and vibration. This system works to keep both
the customer and the operator happy by assuring that the vend that was requested has been completed
successfully.
The Drop Sensor harness must be passed up through the hole in the insulation and attached to the VMC board
at the location shown in
Figure 4
.
Figure 4-
Drop Sensor (ELI2310)
Harness
connection
Drop Sensor
(ELI2310)
Harness that
connects to
VMC
