54
JDL V1.0 8 2022
1. To Home a Vend Motor
a. Unlock and open the Front Door to access the VMC Board, and enter Service Mode by pressing the
MENU Button
b. Enter the Test Vend mode (8)
c. Enter the number of the motor you wish to home. The motor will rotate to its home position.
2. To Remove a Snack Vend Motor
a. Unplug machine from power source
b. Unlock and open the front door
c. Unlock Product Tray and pull it out fully while keeping it level
d. Lift Product tray to release from the Track and pull it out
Caution: The Product Tray Wire Harness will need to be unplugged prior to complete removal of the product
tray. The wiring harness is plugged into the slide-out shelf in the Snack unit.
e. Remove Coil from the driver by lifting the front end of the Coil up with
one hand pinching the lugs of the shaft. Push the shaft through the back of the vend
motor, freeing up the coil/driver/shaft assembly for removal.
Note
: This operation is more difficult with smaller Coils.
f. Remove the two Phillips head screws that are securing the motor to the product tray.
g. Disconnect Wires of the Vend Motor, paying close attention to the orientation of the
motor plug wire connector.
h. Replace Vend Motor by repeating above steps in reverse order, making sure you plug the vend motor
connector in the same way it was originally. Note: Failure to do so may result in vend motor failure.
3.
To Remove a Beverage Vend Motor
a. Unplug machine from power source
b. Unlock and open the front door.
c. Ensure that the selection in question has no products in it.
d. Remove two(2) thumbscrews from the motor.
e. Disconnect wire harness from the motor, paying close attention to the orientation of the motor
plug wire connector.
f. Remove the two nuts that are securing the motor to the plate.
g. Remove and replace motor, then repeat above steps in reverse order making sure you plug the vend
motor connector in the same way it was originally.
PAYMENT SYSTEMS
Coin Changer
The Coin Changer receives and returns change to customers. The Coin Changer will accept Dollar Coins,
Quarters, Dimes, and Nickels. Once the coin tubes reach the required inventory level, all other coins will be
routed into the coin overflow tray.
Loading Changer
As change is given to the customer in coins only, it is recommended that you initially load the coin tubes
completely full when setting up your machine. In order for your VMC to keep an accurate coin inventory, enter
