62
JDL V1.0 8 2022
Unplug the wire harnesses on the right side of the deck and feed the connectors back through the grommet
(Fig. 25). This will prevent damage to the connectors when the deck is removed.
Figure 24 – Refrigeration deck
Wire Harnesses
Rotate both handles outward and pull them toward you to remove them. Remove the guide bolt in the center
of the refrigeration deck (Figure 26). The deck can now be pulled out from the vendor. Please make sure you
unplug wire harnesses prior to pulling all the way out. Do not tip the refrigeration deck more than 20° in any
direction.
Figure 26 – Refrigeration deck removal
Reverse these steps to reinstall the refrigeration deck.
The refrigeration deck is a modular system consisting of Compressor, Condenser, Condenser fan, Evaporator,
Evaporator Fan, Accumulator or Dryer, and Temperature Sensor which communicates to the VMC. The
temperature is pre-set at the factory for efficient and effective operation.
CLEANING THE CONDENSER
Dust and dirt restrict good airflow and cooling of the condenser, causing the refrigeration unit to not chill the
beverages properly. Remove the front bottom panel of the beverage unit. Brush the dirt and dust from the
condenser fins. You can also blow canned air, available at computer and office supply stores, on the condenser
or vacuum clean it. Do not damage the fins of the condenser while cleaning. Reassemble the front bottom
panel after cleaning.
