12
JDL V1.0 8 2022
COIL ADJUSTMENT
If you are required by a location to vend a product that does not fit into the standard coil installed, you may
need to order a different coil and install it. To replace a coil:
1.
Remove the Coil from the Coil Driver by lifting the back of the coil up off the coil driver. You will need to
move the bottom of the coil clear of the coil driver to completely remove the coil.
2.
Align the new coil end with the front of the tray, which gives the coil better contact with the product.
The position of the coil in the coil driver is adjustable to assist you in aligning the new coil at the
front of the tray. See Figure 9.
Figure 9
– Removing and Aligning a Coil
Apply pressure to
the straight part
of the coil that is
inserted into the
Coil Driver. Lift
up on the Coil to
remove.
Coil Driver
with three (3)
adjustment options
Back of Product
Tray, Snack or
Entree
If you are experiencing vending issues with certain products, you may need to adjust the coil rotation to better
provide the momentum to push the snack off the tray and into the delivery area.
To adjust the coil rotation:
1.)
Squeeze the two plastic tabs on the back of the coil driver and pull the coil driver and coil toward the
front of the tray to remove it.
2.)
Turn the coil clockwise 1/8 of a rotation.
3.)
Reinsert the coil driver with coil attached back into the motor, through the back wall of the tray.
4.)
Load the tray and perform at least 5 (five) test vends to ensure a proper vend.
5.)
If the item does not vend consistently, repeat another 1/8 of a rotation until you are confident of
consistent vend function.
