950-0207revA - 14 - November 27, 2013
Installation
paper plank
Side panel fixing screw(M4)
2. Remove the return grille, the side panel and the hanger bracket from the indoor unit as per
procedure below.
a. Press the fixing knob of the air intake grilles, the grilles will be opened wider and then pull them out
from the indoor.
b. Unscrew the side panel fixing screw and remove the side panel. See Fig.4
c. Unscrew the hanger bracket setting bolts (M8) on each side for less than 0.4
”. Remove two hanger
bracket fixing bolts (M6) on the rear side. Detach the hanger bracket by pulling it backward. See
Fig. 6
3. Set the suspension bolt. (Use W3/8 or M10 size suspension bolts)
Adjust the distance from the unit to the ceiling slab beforehand. See Fig.5
4. Fix the hanger bracket to the suspension bolt.
Celling
1 6
. " or less
Hanger bracket
Suspension bolt
Celling slab
BO
LT
PO
SIT
IO
N
IN
W
A
R
D
Hanger bracket
Hanger bracket
setting bolt(M8)
Hanger bracket
fixing bolt(M6)
Hanger bracket
WARNING:
●
Make sure that extended suspension bolt from the ceiling stays inside the appointed position.
Readjust the hanger bracket when it is out of the appointed position. See Fig. 7 above.
● Suspension bolt is fixed in the cap of indoor unit. Never remove the cap.
5. Lift the unit and slide forward unit in place. See Fig. 8 above.
6. Screw tightly both hanger bracket-setting bolts (M8). See Fig. 6 above.
7. Screw tightly both hanger bracket-fixing bolts (M6) to prevent the displacement of the indoor unit.
See Fig. 6 above.
8. Adjust the height so that rear side of the drainpipe slightly inclines to improve drainage.
Figure 5
.
Figure 3
.
Figure 4
.
Figure 6
.
Figure 7
.
Figure 8
.
