Sea Tel ST14, Installation And Maintenance Manual

Page: 19 / 84

ST14 Ku-Band TVRO Installation
1-13
1.14.2.3.1.
Connect an available output port of the Multiswitch to the Splitter/Multiswitch port of a
Slave DiSEqC Switch. Repeat as required for each switch installed.
Multi-Switch to Slave DiSEqC Switch (multiple receivers)
1.14.2.3.2.
Connect the Receiver (SAT IN) port of a Slave DiSEqC Switch to the satellite in port of a
slave satellite receiver. Repeat as required for each receiver installed.
Slave DiSEqC Switch to receiver (multiple receivers )
1.14.3.
Connect and secure the RS232 Serial Cable from the ACP serial port to the Master DiSEqC switch’s serial port
labeled M&C to ACP/DAC.
Serial Cable
1.15. Installing the Cables for Model ST14 M:
1.15.1.
Connect the antenna cable to the antenna control panels “RF IN” port.
Antenna M&C
1.15.2.
1.15.2.1. ACP to DeStacker
IF Cables
Connect the ACP’s “RF OUT” Port to the Stacked DBS + Antenna input of the DeStacker.
1.15.2.1.1.
Connect and secure “RCVR1” to the “SAT IN” port of a satellite receiver.
DeStacker to Receiver (1-2 receiver setup only)
Connect and secure “RCVR2” to the “SAT IN” port of a secondary satellite receiver
1.15.2.1.2.
Connect and secure the “RCVR1” port of the DeStacker to the Horizontal (+13Vdc) input
port of the active Multiswitch.
DeStacker to Multiswitch (3+ receiver setup only)
Connect and secure the “RCVR2” port of the DeStacker to the Vertical (+18Vdc) input port
of the active Multiswitch.
1.15.2.1.3.
Connect and secure an available output port of the active matrix switch to the “SAT IN”
port of a satellite receiver.
Multi-Switch to Receiver (3+ receiver setup only)
Repeat as required for all installed satellite receivers.
1.16. Installing the Cables for Model ST14 E
1.16.1.
Connect the antenna cable to the Antenna Control Panel’s “RF IN”.
Antenna Cable
1.16.2.
Connect ACP’s “RF OUT” port to the “SAT IN” port of a satellite receiver.
Satellite Receiver IF Cable