Sea Tel ST14, Installation And Maintenance Manual

Page: 50 / 84

Setup for Model ST14E ST14 Ku-Band TVRO
4-8
1. Press the
NEXT
key to SELECT this sub-menu parameter for adjustment.
2. A cursor will appear under the leftmost digit. Press
▼
&
▲
arrow keys to
increment/decrement this digit.
3. Press the
NEXT
key to move the cursor to the next digit to the right. Press
▼
&
▲
arrow
keys to increment/decrement this digit.
4. Press the NEXT key to move the cursor to the next character to the right. Press ▼ & ▲
arrow keys to toggle this character between N (North) and S (South).
5. Press the SAVE key to save the current ships latitude in the LAT parameter.
4.3.6.4. LON (Ships Longitude)
This parameter is automatically set by the GPS antenna mounted on the Coastal pedestal inside the
radome. The GPS input enables the antenna to quickly & accurately target satellites (SATA – SATC)
when you press the
NEXT
key on the Antenna Control Panel.
1. Press the
NEXT
key to select this sub-menu parameter for adjustment.
2. A cursor will appear under the leftmost digit. Press
▼
&
▲
arrow keys to
increment/decrement this digit.
3. Press the
NEXT
key to move the cursor to the next digit to the right. Press
▼
&
▲
arrow
keys to increment/decrement this digit.
4. Press the NEXT key to move the cursor to the next digit to the right. Press ▼ & ▲ arrow
keys to increment/decrement this digit.
5. Press the NEXT key to move the cursor to the next character to the right. Press ▼ & ▲
arrow keys to toggle this character between E (East) and W (West).
6. Press the
SAVE
key to save the current ships longitude in the LON parameter.
4.4. Saving the SETUP Parameters
When you have completed setting the desired parameters above, Press and Hold
SAVE
for 6 seconds to save the
changes you have made to the settings and exit SETUP Mode. “Settings Saved” will be displayed.
If you do NOT want to save the changes to NVRAM, Press
SAVE
+
▲
to exit SETUP Mode without permanently saving
any parameter changes.
NOTE: You will save individual set-up parameter settings as you modify them in the procedure
below (quick presses of the SAVE key). These will only save the settings until POWER is cycled to
the antenna.
When you are finished making all of your desired changes, you MUST press and hold the SAVE
key for six seconds
to write the changes you have made to memory (“Settings Saved” will be
displayed) in the PCU, so they will be available after POWER has been cycled to the antenna.