Sea Recovery SRC Ultra Whisper Compact 200, Owner'S Manual

Page: 159 / 299

Sea Recovery Ultra Whisper Rev. A
f. POSSIBLE CAUSE: HIGH PRESSURE SEALS WITHIN THE ETD HIGH PRESSURE CHAMBER ARE
WORN OR HAVE SLIPPED OUT OF THEIR PROPER POSITION.
1) Press Reset Fault Switch to reset and turn off the “High/Low Pressure” Fault Lamp.
2). Start the System
IF The Feed Pump Inlet Compound Vacuum/Pressure Gauge [5] registers normal at zero to slight vacuum, the
Prefilter Inlet Pressure Gauge [12] registers far below normal, the Prefilter Outlet Pressure Gauge [16]
registers far below normal pressure, and the High Pressure Gauge [18] does not register at all this would
indicate that the High Pressure Seals within the ETD require replacement. See ETD Troubleshooting later in
this Section.
50
100
150
200
250
300
0
PSI
PSI
1400
1200
1000
800 600
400
200
0
PSI
0 300
250
200
150
100
50
IN HG
PSI
70
60
50
40
30
20
10
-30
0
[5]
FEED PUMP INLET
COMPOUND
VACUUM / PRESSURE
-30 - 0 - 60 PSI
[12]
PREFILTER INLET
PRESSURE GAUGE
0 - 300 PSI
[16]
PREFILTER OUTLET
ETD INLET
PRESSURE GAUGE
0 - 300 PSI
[18]
OPERATING PRESSURE
DEVELOPED BY THE ETD
0 - 1500 PSI
1. While the System is operating check the Brine Discharge Line and look for a steady stream, non
pulsating stream, of Feed Water coming out of the Brine Discharge Thru Hull Fitting [23]. If there is a
steady stream, without pulsations, of Feed Water discharging over board to waste then refer to ETD
Troubleshooting later in this section.
section 6 page 12 of 38