Sea Recovery SRC Aqua Matic 1400-2, Owner'S Manual, Page: 65 / 223

Manual System Check
1. Ensure that the manual bypass lever on the 3-Way Product Water Diversion Valve is positioned outward (away
from the coil body).
2. Open any auxiliary valve within the incoming Feed Line, Outgoing Brine Discharge Line and Outgoing Product
Water Line.
Caution: If an auxiliary valve is installed within these lines and is closed during System start and/or
operation, it will damage the System. The resulting damage is the liability of the Operator and is not
covered by the Sea Recovery Corporation warranty.
3. Position Rinse-Clean Inlet Valve to normal operation towards the Sea Strainer.
4. Position Rinse-Clean Outlet Valve to normal operation towards the Thru Hull Discharge Fitting.
5. Check all filter housings to ensure that they contain the proper filter element.
a) Sea Strainer: Check for monel screen.
b) Plankton Filter (if installed): Check for monel fine-mesh screen filter element.
c) Multi Media Filter (if installed): Check for media (#20 silica sand).
d) Dual Pre-filter or Commercial Pre-filter: Check for pleated cartridge filter elements.
e) Oil/water Separator: Check for Oil/Water Separator filter element.
f) RO Membrane Element(s): Check for Sea Recovery Serial Number and date on the label that is attached
to each pressure vessel.
g) Charcoal Filter: Check for charcoal filter element.
h) pH Neutralizer: Check for pH Neutralizer cartridge.
i) Fresh Water Flush Carbon Filter: Check for Carbon element.
6. Perform function tests on electric components. Prior to assuming that an electrical component is broken or
non-functional, perform a function test to determine if it is operable. Function tests should be performed manually
for the following components, as part of the commissioning procedures:
• Booster Pump Electric Motor
• High Pressure Pump Electric Motor
• Diversion Valve Energize Solenoid
63