Sea Recovery SRC Aqua Matic 1400-2, Owner'S Manual, Page: 44 / 223

System Valve Positions
Note: The Inlet Thru-Hull Sea Cock Valve is in the OPEN position. It is recommended (for ship safety) that
you close the Sea Cock Valve whenever the System is not in use. This will protect the ship from flooding,
should a hose or component fail.
Position Valve
Full Open Inlet Sea Cock Valve
From Sea Strainer to Fresh Water Flush Valve Rinse Clean Inlet Valve
From System brine discharge to Thru Hull Discharge Fitting Rinse Clean Outlet Valve
Normal Operation Multi Media Filter Valves
Full Open ANY auxiliary valve in the Feed Line, Brine Discharge Line or Product
Water Line
Caution: If an auxiliary valve is installed within these lines and is closed during System start and/or operation,
it will damage the System. The resulting damage is the liability of the Operator and is not covered by the Sea
Recovery Corporation warranty.
Controller Setup
The controller is set by Sea Recovery Corporation prior to shipping, based on the ordered System features and
optional equipment. The addition of the Fresh Water Flush to the System after it has shipped from Sea Recovery
requires updates to the computer logic setup. The addition of, removal of, or changes to the length of the RO
Membrane Element / Pressure Vessel Assembly requires updates to the control logic setup. Please refer to the
Programming Kit Manual for details. The information below is an explanation of Operator-programmable features.
Each feature must be set properly in order to gain maximum System performance. Only pre-installed features will
be displayed on the screen.
1. Manual Mode: Enables user to control the Booster Pump, HP Pump, Diversion Valve and Pressure.
Aqua Matic Compact 450-1800 42