Sea Recovery SRC Aqua Matic 1400-2, Owner'S Manual, Page: 133 / 223

131
61
Product water quality lost.
Possible feed water quality issue.
Attempting to rectify.
The system is running in automatic mode and was
producing potable water, but for some unknown
reason the water quality of the product water
deteriorated and is no longer acceptable. Check system
pressure settings
62
High pressure pump hours high.
Mechanical inspection of pump
recommended.
The high-pressure pump has run for more than the
recommended maximum number of hours between
services, and now requires inspection. This detailed
service is highly recommended to extend the life of
your unit
63
High pressure pump oil hours
high. Pump oil replacement
recommended.
The high-pressure pump has run for more than the
recommended number of hours between oil
inspections, and now requires this inspection or
possible oil change. This quick service is highly
recommended to extend the life of your unit.
64
Brine flow sensor in by-pass
mode. Emergency operation
mode active.
The operator has activated the emergency by-pass of
the system brine flow sensor, and is now operating the
system. Operation can continue until the maximum
preset time has elapsed (50hrs). Contact Parker for
additional information
65
Tank level control detected
product tank full. System will
restart when tank is low.
The vessel potable water storage tank reports being
full, and the system has been stopped to avoid
overflowing of this tank. Once the tank reports low
levels the system will re-start automatically, providing
the user has not operated the system and power to the
system has not been disconnected.
66
System HP pump output below
minimum. Please increase system
pressure using BPR
The system was started in either manual mode or the
system is an AquaWhisper DX. Once the HP pump is
activated, the user has a finite time in which to adjust
system pressure to above minimum (>250PSI), if this
step is not taken within 60 seconds of pump activation,
the system automatically generates this message. If the
pressure is not increased above minimum with a 10-
minute period, the control system will shut the water
maker down