Installation Instructions for the
Junction Alarm System
SK-103KLE
LE Keypad Alarm Module
SK-107J
Junction Box
SK-10106J
6 Port Junction Splitter
SK-96-1068
12" (Str. Wire) Mini Phone Sensor
SK-195
AC/DC Power Supply
SK-1912
Bug Sensor Removal Tool
SK-96-1069
12" (Str. Wire) Bug Sensor
SK-98-1014
12" Dual - Ant w/Strap & Mini Phone Sensor
Strap for Ant Sensor
SK-99-12J (12") SK-99-48J (48")
12" & 48" (Str. Wire) Extensions w/Mini Phone Connectors
SK-159J
Mini Shunt Plug w/Resister
SK-109
Standard Shunt Plug
Battery Installation:
1.
With a Standard Blade Screw Driver, remove the (4) four screws
around the base of the “LE” Alarm Module. Make sure the alarm
is in the “Stand-By” position and lift off the cover.
2.
Install (2) two new 9-volt Alkaline, (such as Duracell) batteries,
(not included) inside the “LE” Alarm Box by first positioning them
on the connectors attached to the circuit board and then pushing
them firmly into place, as shown in Fig. 1 to the right). The Power
Test Light (yellow) should flash indicating that the power is on.
This light will flash every 15 seconds indicating that the batteries
are in good working condition and the power is supplied to the unit.
Note: When the yellow light flashes and simultaneously the horn “chirps” twice the
batteries need to be replaced immediately.
3.
Replace the cover onto the “LE” Alarm Module and Re-Install the (4) four screws
around the base.
AC/DC
Adapter
Connection
(back)
(Coupler)
Power
Test
Light
Circuit Test Light
Alarm Box Screws
Keypad
SK-103KLE
Fig. 1
