(SENSOR ATTACHMENT PROCEDURE)
Sensor Connections: –
to Product
The SK-904 Series Rectangul;ar Sensor:
Choose a small flat area on the back of the
product where the sensor is to be applied.
VERY IMPORTANT!
NOTE: Clean the area on the product and the sensor with an Alcohol
Prep Pad. Wipe these surfaces Dry. with a clean paper towel. If the
paper towel shows dirt, REPEAT THIS CLEANING STEP until the sur-
faces are CLEAN & DRY!
Remove an SK-905 (1"x2") rectangular adhesive pad from its backing
sheet. Making sure that the center hole has been removed from the
adhesive, apply it to the cleaned surface on the bottom of the rectan-
gular sensor. Press it firmly into place, (see Fig. 3).
Remove the backing sheet from the other side of the adhesive pad and
position the rectangular sensor over the flat area of the product previ-
ously cleaned. Press the sensor firmly into place to insure a proper
bond, (see Fig. 4). The light on the sensor will change to RED when the
sensor is applied correctly to the product.
1.
2.
3.
SE-KURE CONTROLS,
®
INC.
3714 Runge Street • Franklin Park, IL 60131-1112
1-800-322-2435
SK-905
Rectangular
Adhesive Pad
Rev. 7/26/04 ©2004 Se-Kure Controls,
®
Inc.
SCI-9762
Remove
this
adhesive
backing
Fig. 3
Fig. 4
Clean & Wipe Dry
