Se-Kure Controls,
®
Inc.
3714 Runge Street • Franklin Park, IL 60131 • 1-(800) 322-2435 • (847) 288-1111 • Fax: (847) 288-9999
Rev. 10/15/98
SCI-9619
©1998 Se-Kure Controls,
®
Inc.
SK-10106J
6 Port Slatwall
Splitter
#1
#2
#3
#9
#10
Do Not Use
This Port
Leave the
SK-109
Shunt Plug
in this Port!
SK-103KLE
LE Alarm Module
SK-107J
Junction Boxes
SK-99-12J
12" (Str. Wire) Extensions
Coupler
SK-159J
Mini Shunt Plug w/Resister (from Junction Splitter)
4.
Connect the (SK-195) AC/DC Power Supply to the jack on the rear of the “LE” Alarm Module. Be sure to insert the
plug fully into the jack! Plug the other end of the AC/DC Power Supply into a standard 110-115v AC wall outlet.
Note: If NO BATTERIES ARE INSTALLED, the yellow light will flash and simultaneously the alarm horn will “chirp”
twice until the batteries are installed or the power is disconnected.
5.
Position the 6 Port ”Junction Splitter” on the side of
the slatwall closest to a standard 110v outlet.
6.
Plug the Junction Splitter into the “Coupler” attached
to the (SK-103KLE) Alarm Module.
7.
Remove an (SK-159J) Mini Shunt Plug from the
Junction Splitter, and plug a 48" (SK-99-48J)
Extension into that port.
8.
Remove the Velcro backing from a (SK-107J)
Junction Box, and place it over the slot at the
beginning of the slatwall.
9.
Plug the other end of the 48" Extension, (from the
Junction Splitter) into the side of the Junction Box,
and a 12" (SK-99-12J) Extension into the other side.
10.
Each row should be connected with Junction Box -
12" Extension - Junction Box - 12" Extension etc. . .
11.
Plug the (SK-159J) Shunt Plug (removed from the
Junction Splitter) into the last Junction Box in the row.
12.
Repeat this procedure for all rows as laid out by your
store planogram.
13.
Plug a sensor into the front port of a Junction Box
(Bug, Mini Phone, or Dual -Ant/Mini Phone).
Special Note:
This is a “Closed Circuit” System, and requires all
ports to be filled. You must have either a sensor or a
shunt plug in every port.
Operation:
The Slatwall Junction Alarm System operates in much the
same as the “LE PLUS” Alarm System... When a sensor
has been disturbed, the light on the sensor and the
Junction Box will flash “RED”, and the GREEN light on the
Junction Strip will flash to indicate which row has been
affected.
Follow the LE & Keypad Instructions for
additional information.
SK-99-48J
48" (Str
. Wire) Extensions
