Red LED
Green LED
Fast Flash
Solid
P:\INSTALLATION INST\Access Control\INST-936.vsd 0106 Page 14
Programming the Control Module with the Keypad
To set up and program the system using the Keypad, proceed as follows. The System
Setup can only be modified if you know the Master Code (Default: 123). When the system is
initially set up, the default system settings should be reviewed prior to other programming.
To enter Control Module Setup mode
:
Enter
* 3
Enter the Master Code followed by
#
Example:
* 3 1 2 3 #
Proceed to one of the following eight programming options:
1.) Chan
ging the Master Code (Default: 123)
A. Enter
1 #
B. Enter the New Master Code (3-8 digits) followed by
#
C. Select another programming option (1-8) or enter
* *
to exit programming.
Beep Red LED
Green LED
Double Fast Flash
Slow Flash
Beep Red LED
Green LED
Triple Fast Flash
Solid
Note
: If you forget the Master Code, locate and press the PROGRAM button on
the Control Module board. This will take you into System Setup. Once you enter
setup mode, you have 30 seconds to begin the program sequence.
2.) Setting the Main Door Open Time (Default: 5 Seconds)
A. Enter
2 #
B. Enter the desired Door Open Time (1-99 seconds), followed by
#
Example:
2 # 1 5 #
(15 sec. Door Open Time)
C. Select another programming option (1-8) or enter
* *
to exit programming.
Beep Red LED
Green LED
Double Fast Flash
Slow Flash
Beep Red LED
Green LED
Triple Fast Flash
Solid
3.) Setting Latching Option (Main Relay) (Default: Off)
A. Enter
3 #
B. Select the desired latching option:
Off
–
0 #
Manual – 9 9 #
Timed
– Enter the desired time interval in hours (1-98), followed by
#
.
Example:
3 # 8 #
(Sets timed latching for 8 hrs)
C. Select another programming option (1-8) or enter
* *
to exit programming.
Beep Red LED
Green LED
Double Fast Flash
Slow Flash
Beep Red LED
Green LED
Triple Fast Flash
Solid
