P:\INSTALLATION INST\Access Control\INST-936.vsd 0106 Page 9
KEYPAD RESET
In certain cases you may want to erase all user codes and restore system defaults. To
perform this procedure:
CAUTION
: This procedure completely erases the memory and restores factory
defaults! Once the memory is cleared, all programmed User Codes are erased
and factory default settings are restored.
1. Remove power.
2. Jumper the two pins above the connector labeled “CONFIG”.
3. Apply appropriate power. (You should hear 4 beeps and the RED LED will flash and the
GREEN LED will be solid).
4. Once the Keypad is in configuration mode, enter 0099#. The Keypad will beep twice and
both LEDS will flash for approximately 10 seconds. (During this time, the Keypad will appear
dead. Do NOT remove power!)
5. Enter 98 followed by #. You should hear 3 beeps indicating successful completion (the
RED LED will continue to flash and the GREEN LED will be solid). If you hear a long error
beep, re-enter 98 followed by #. To change the audible beep or illumination, proceed as
follows. Otherwise, go to step 6.
a. To change the audible beep, enter the code as follows:
Code Audible Beep
201 # Normal Beep (factory default)
200 # Short Click (quieter)
b. To change the illumination on the KP-31Y only, enter the code as follows:
Code Standby Mode
Normal Operation
210 # Off (factory default)
Off (factory default)
211 # Off
Dim
212 # Off
Bright
213 # Dim
Dim
214 # Dim
Bright
6. Remove power.
7. Remove configuration jumper.
8. Re-apply power.
9. Press the PROGRAM button in the Control Module to establish the encoded connection.
This will put the system into setup mode.
10. Press * * to exit.
RESTORING SYSTEM DEFAULTS
