scigiene NV-N20K48, User Manual, Page: 9 / 56

9/57
3.2 PANEL INSTALLATION
N20K48 Modular Controller is suitable for panel installation. You should install it according to the steps below:
•
Make a cut-out in the panel as specified in the technical specifications table (see SPECIFICATIONS chapter).
•
Remove the controller fixing clips.
•
Insert the controller in the panel.
•
Replace the fixing clips on the controller, attaching them as shown in the figure below:
Fixing clips
3.3 HOW TO ATTACH THE DOCK TO THE CONTROLLER
You must attach the dock to the back of the N20K48 Modular Controller , as shown in the figure below:
Attaching the dock to the controller
To attach it to the device, simply press it down until you hear it click into place. To remove it, we recommend using a
screwdriver, which can help you release the side locks without damaging the product.
3.4 HOW TO ATTACH A MODULE TO THE DOCK
Once you have attached the dock to your device (as shown in the DOCK section of this chapter), you can add one or more
ClickNGo modules to it. To do so, simply insert the module into the dock and press it down until you hear it click into place.
If the module is not positioned correctly, it is either not plugged in properly or it has been plugged in at an incorrect position.
You cannot add modules of sizes 2 and 4 between inputs 2 and 3 and inputs 6 and 7. You can use modules of different
sizes up to the limit of the dock physical space.
Before inserting or removing a ClickNGo module, make sure the device has been turned off.