12
/57
4.3
ACCESSING CYCLES AND CONFIGURATION PARAMETERS
N20K48 Modular Controller
has configuration parameters, which have been gathered into affinity groups, called Cycles.
As shown in the figure below, there is the
Operation Cycle
and the
Configuration Cycles
, composed of Control, Alarms,
Input, Output A, Output B, Modules (1 to 8), Programs, Timer, and Calibration:
N20K48
Cycles
To navigate between cycles, as shown in the figure above, you must press the
key for three seconds. Once in the
desired cycle, simply click the
key until you find the parameter that you want to configure. You must use the
or
keys to change the condition/value of the desired parameter.
In either case, the
key allows you to go back.
To view the parameters of each cycle, please refer to the following figure:
Cycles and parameters groups