20
/57
PRG
Program
Program execution. Allows you to select the Ramps and Soaks program to be executed.
NONE
– Do not execute any program
1
to
20
– Number of the program to be executed
With the outputs enabled (
RUN
=
YES
), the selected program will be executed immediately.
You must set the parameter Enable Program Function (
PRG.E
) of the Timer Cycle (
tm
) to
yes
or
no
to
display this parameter in the Operation Cycle.
Sp.a1
Alarm SP. Allows you to define the actuation point for alarms programmed with
Lo
or
Hi
functions.
Sp.a2
This parameter defines the deviation of alarms programmed with
Differential
type functions.
Sp.a3
This parameter is not used for other alarm functions.
Sp.a4
Setpoint
Alarm
You must set the parameter for the desired Alarm Setpoint (
E.SPA1
,
E.SPA2
,
E.SPA3
or
E.SPA4
) of the Alarm
Cycle (
ALM
) to
yes
or
no
to display the Alarm Setpoint parameters in the Operation Cycle.
p.seg
Progra
m
Segme
nt
Indicative screen only. When a program is running, displays the number of the running segment of this
same program.
t.seg
Time
Segment
Indicative screen only. When a program is running, displays the time left to finish the running segment.
Displayed in the time unit adopted in the Programs Time base parameter (
CFG
>>
PROG
>>
Pr.tb
).
RUN
Allows you to enable control outputs and alarms.
YES
– Enabled
No
– Disabled
You must set the parameter Enable Function RUN (
RUN.E
) of the Calibration Cycle (
CALIB
) to
yes
or
no
to
display this parameter in the Operation Cycle.
Table 6
–
Operation cycle
