25
/57
4.3.4 INPUT CYCLE (
CFG
>>
IN
)
This is the Input Cycle:
Input Cycle
Type
Type
Input type. Allows you to select the input type to be used. See table in
section.
You must configure this parameter first.
fLtr
Filter
Input filter. The filter is used to improve the stability of the measured signal (PV). Adjustable between 0 and 9999.
At 0, it means that the filter is off. At 9999, it means that the filter is at maximum. The larger the filter, the slower the
response of the measured value.
unit
unit
Allows you to set the temperature unit: Celsius
°
C
or Fahrenheit
°
f
.
Dp.po
decimal
Point
Allows you to define the decimal point position in SP and PV values:
0
– No decimal places
0.0
– One decimal place
When configuring the input parameter (
TYPE
) with temperature sensors (J, K, Pt10 etc.), in addition to the integer part
of the measurement, only decimal values (XXX.X) will be displayed.
For linear signals (mA, mV, V), this parameter determines the decimal point position of the measured value (XXXX,
XXX.X, XX.XX, X.XXX).
IN.LL
Input Low
Limit
Indication range limits for the selected linear input.
Parameters available for
linear inputs
only (see table in
section).
IN.HL
Input High
Limit
0ffs
Offset
Allows you to adjust the indicated PV value. Default value: 0.
sQRt
Square Root
Square Root Function. Applies the quadratic function on the input signal, within the limits programmed in parameters
SPLL
and
spHL
.
YES
– Enables.
no
– Disables.
