10
CONSOLE SERVICE MODE
The Console Service Mode lets you set the units of measurement to either English or Metric, see the total time and
distance the machine has been used, adjust the altitude value for a more accurate calorie count, or find out which version
of Firmware is installed.
1. Hold down the Increase button and Decrease button together for 3 seconds while in the Idle Mode to go into the Con-
sole Service Mode.
2. The Console display shows the Units prompt ( “Unit” ). Push START/STOP to start Units option. Push the Increase/
Decrease buttons to change between “M” (Imperial English units) and “KM” (metric units).
3. Push START/STOP to set. For the next option, push the Increase button.
4. The Console display shows the Workout Statistics prompt ( “StAt” ). Push START/STOP to start the Workout Statistics
option. The Console will display the Total Distance ( “Odo” ) and Total Time.
Note:
The upper displayed value shows the total hours followed by the remaining minutes.
5. Push START/STOP to exit. For the next option, push the Increase button.
6. The Console display shows the Firmware Version prompt ( “Fir” ). The Console will display which Firmware Version is
installed in the Speed display field.
7. For the next option, push the Increase button.
8. The Console display shows Altitude ( “Alt” ) with the previously entered value in the Speed display field. Push START/
STOP to adjust the Altitude value. Use the Increase/Decrease buttons to change the value.
9. Push START/STOP to exit. For the next option, push the Increase button.
10. The Console display shows the exit prompt ( “dOnE” ).
11. Push START/STOP to exit.
To fully exit the Console Service Mode push and hold down the START/STOP button for 3 seconds. In Service Mode if the
Console does not receive any input in approximately 5 minutes, it goes into Sleep Mode.
