Schweitzer Engineering Laboratories SEL-387-0, Instruction Manual

Page: 366 / 568

8.8
SEL-387-0, -5, -6 Relay Instruction Manual
Date Code 20050919
Front-Panel Interface
Pushbuttons
TAR
This command is roughly equivalent to the TAR F serial port command.
When
TAR
is selected in the
OTHER
main menu, the display shows
TAR 0
, the
first row of the Relay Word bits, with
EN
shown in the second row (relay
enabled). The up/down arrow keys can be used to scroll through the remaining
rows of the Relay Word bits. For these rows, the asserted Relay Word bit
names will be listed in the second row of the display, and the corresponding
LED positions will be lit in the target area above the display. If more bits are
asserted than will fit in the display, the right/left arrow keys can be used to see
the off-screen names.
Push {CANCEL} to return to the
OTHER
main menu. Push {EXIT} to return to the
default display.
TIME
This command works like the
DATE
command above and is equivalent to the
TIME serial port command.
When selected, a two-line display appears, with the current time on the first
line and a prompt to
Set
or
Cancel
on the second. Use the right/left arrows
and
{SELECT}
to choose. Since this is a Level 1 command, it is not password
protected from the front panel. If
Set
is selected, a second display appears
prompting the user to change the time. Use the right/left arrows to move
between the HH:MM:SS fields and the up/down arrows to scroll to the
number selected for the field. When the time is shown correctly, push
{SELECT}
to enter it. Push
{CANCEL}
to return to the
OTHER
main menu. Push
{EXIT}
to
return to the default display.
SET
The SET function has the most elaborate menu and display structure of all the
pushbutton functions. Only numeric value settings or settings having fixed
Character string values can be displayed or changed on the display. Settings
that are
SEL
OGIC
control equations cannot be displayed or changed.
To show or set relay settings, press the
{SET}
button. There are four set/show
options:
GROUP
,
GLOBAL
,
PORT
, and
PASS
. Use the right/left arrow keys and
{SELECT}
to choose. These will be discussed in alphabetical order.
Figure 8.8 , at the end of this section, shows the essential menu and display
structure for the
{SET}
button. It does not show anything below the setting
section (subgroup) level, since this would be too cumbersome.
GLOBAL
This command is roughly equivalent to the SHO G and SET G serial port
commands. When
GLOBAL
is selected, a menu appears for selecting whether to
Set
or
Show
the settings. If
Set
, a password entry screen appears if password
protection is in force.
The next screen is either the
Set GLOBAL
or
Show GLOBAL
display, in which a
message scrolls across the second line, reminding the user to
Press TARGET
RESET for help during set/show routine
. This special use for the
{TARGET
RESET} pushbutton provides the user with a short description of the setting and
the range of values, should the user not recognize the setting by its Character
string name.
NOTE:
After setting the time, allow
at least 60 seconds before powering
down the relay or the new setting may
be lost.