SCHUNK HGN 100, Assembly And Operating Manual

Page: 27 / 36

Maintenance and Care
01.00|HGN |en 27
Servicing and assembling the module
• Clean all parts thoroughly and check for damage and wear.
• Treat all greased areas with lubricant.
(

9.3, Page 24)
• Oil or grease bare external steel parts.
• Replace all wear parts / seals.
– Position of the wearing parts
(

10, Page 31)
– Seal kit
(

11, Page 32)
Assembly takes place in the opposite order to disassembly. Ob-
serve the following:
• Unless otherwise specified, secure all screws and nuts with Loc-
tite no. 243 and tighten with the appropriate tightening
torque.
(

9.5.2, Page 28)
Assembly and calibration of seals
Position of the position numbers
(

10, Page 31)
Fig. 7
1 Expansion sleeve 2 Seal (14)
2 Mounting taper 4 Cylinder piston (6)
5 Calibration sleeve
9.5
Maintenance
Assembly
9.5.1
Assembly and calibration
of the piston seal (14)