Overview | Buttons and LED in the event of an alarm
B-HB-0133EN
Operating panel Integral MAP | User manual
9
3.2.3
Exploration/intervention function
(Depends on programming; delay function must be activated)
If an alarm is received with the delay layer activated, the beep acknowledgement time
sounds and the LED next to the button
Intervention
C
flashes. Pressing the button
Intervention
C
within the acknowledgement time activates the intervention/interven-
tion mode. The LED next to the button lights up and the signal tone changes from ac-
knowledgement time to intervention/intervention mode. The activation of the main de-
tector output is delayed by the programmed intervention time.
Pressing and holding the button
Intervention
C
within the intervention time shows the
remaining intervention time on the display.
Further Information:
Activate exploration/intervention function
3.2.4
Reset alarm/fault signal
Pressing the button
Buzzer silenced
D
disables the signal tone of an active alarm or
fault message in the fire alarm control panel; the LED remain lit up. Any additional alarm
or fault message will trigger the alarm and fault signal tones again. Acknowledgement
and intervention signal tones cannot be reset.
Summary of Contents for Integral MAP
Page 1: ...Operating panel Integral MAP User manual FIRE ALARM EN ...
Page 2: ......
