General operations | Operation release (authorisation levels)
22
Operating panel Integral MAP | User manual
B-HB-0133EN
2.
Enter the number of the element to be selected using the numerical buttons of the
keypad
X
.
NOTE
If an individual detector of a detector zone is to be queried, enter the de-
tector number in addition to the detector zone number, separated by a slash
(
/
).
3.
Confirm with the enter button
D
. If an element has been selected, then the ele-
ment’s current status is shown on the display.
u
The selected element can now be operated according to the authorisation level.
Pressing the button
Site Info
J
or
Additional Information
Y
displays additional in-
formation about the element.
5.4
Operation release (authorisation levels)
| Operation release (authorisation levels)
For each operating panel, different authorisation levels can be programmed with a vary-
ing range of functions. The system is set to the lowest authorisation level as standard
(level 1). The
Access Code
K
LED lights up, if a level higher than access level 1 is
entered.
In level 1 it is possible in standard configuration to reset the alarm/fault signal (
).
NOTE
An authorisation code must be entered for further operating and indication
processes.
5.4.1
Change authorisation level
CAUTION
Unauthorised access to the fire alarm control panel
Only authorised persons may be able to access to the fire alarm control
panel using the authorisation code. Note or save the authorisation code at a
safe place and protected it from unauthorised access.
1.
Pressing the button
Access Code
K
.
2.
Enter the access code of a higher authorisation level using the numerical buttons of
the keypad
X
.
Summary of Contents for Integral MAP
Page 1: ...Operating panel Integral MAP User manual FIRE ALARM EN ...
Page 2: ......
