16
–
Fix the cover strip onto the edges by applying gentle pressure.
–
In the case of multi-part cover strips, position and attach the next cover
strip without any seams.
–
In the case of multi-part rails, the cover strips and rails are not of the same
length. Ensure that the butts of the rails and cover strips do not lie over
each other.
4.
Slightly oil the cover strip with lubricant, see section 9.2.
5.
Run the carriages back onto the rail, see section 8.2.
•
It is possible to fit and remove the cover strip before bonding. There is no
need to pull off the protective film. Tap the cover strip with gentle pressure
onto the edges over the rail, see above.
•
To remove non-stuck cover strips, raise one end of the cover strip with a
screwdriver and carefully remove it.
When doing so, ensure that the cover strip does
not
bend!
Multi-part cover strips
Installation note