EasyBus - Signalling and Switching Bus System
Installation, Operating and Maintenance Instructions
Safety instructions | Recycling
Construction subject to change
No return possible
Version: 2017-11-13 | Page 2
SAFETY INSTRUCTIONS
Before installing and commissioning the EasyBus
components, carefully read the entire manual. Take note in
particular of the operating instructions containing hazard
symbols and warning signs. Their non-observance could result
in damage to the unit and slight to serious personal injuries.
Should you have any questions, after reading through the
entire manual, please contact SCHAKO.
An exclamation mark within a triangle
indicates information which must be observed
by the user. Non-observance may result in
damage to the module or loss of data.
A lightning flash within a triangle warns
against
electric shock or impairment of the electrical
safety of the device.
This symbol indicates important information in
these operating instructions which must be
observed.
GENERAL INFORMATION
Inspection, installation, connection and commissioning of
the EasyBus components may be carried out by skilled
personnel only in compliance with current regulations.
The EasyBus components must not come into contact with
liquids.
The EasyBus components must not be operated with wet
hands.
Control and safety elements must not be modified without
approval by the manufacturer or the regional sales
representative.
The electric connections and their proper functioning are
the responsibility of the installer.
SCHAKO will not be responsible for any damage caused by:
incorrect installation due to non-observance of the
instructions of the present manual.
installation and maintenance not carried out by skilled
personnel.
non-observance of the operating conditions of the EasyBus
components.
improper use of the EasyBus components or under
inadmissible conditions according to the present manual.
WARRANTY
The warranty for the EasyBus components is two years from
the acceptance date for manufacturing errors. This does not
apply to the included electric components to which the
warranty of the manufacturer in question applies. The
warranty does not cover damage to the unit caused by
components that do not belong to the equipment
components. The warranty only covers the return and
replacement of defective parts.
RECYCLING
Contact a certified electronic waste disposal company for
environmentally friendly recycling and disposal of EasyBus
components.
GENERAL INFORMATION ABOUT EASYBUS
The signalling and switching bus system SCHAKO EasyBus can
be used, among other things, for activating and monitoring
mechanical and electrical fire dampers with
24V DC or 230V AC spring return actuator, smoke extraction
dampers, smoke detectors and volumetric flow controllers
with 0(2)-10V activation or air diffusers with 2/3-point
motorised drives.
MODULE OVERVIEW
For individual areas, we are offering the following modules
for signal processing and monitoring:
Type Description Function
EasyS-MV1
EasyS-MV2
Master
Modulation of the bus
signal
EasyF-ADC
EasyF-AAC
Motorised drive
module
Control of a motorised
drive and detection of its
end positions
EasyF-VDC
EasyF-VAC
EasyF-VMP
Analogue closed-
circuit and open-
circuit control
module
Closed-circuit and open-
circuit control of steadily
controlling drives
EasyF-RMM
Smoke detector
module
Monitoring and
evaluation of the smoke
detectors
EasyF-IOM
Input / output
module
Monitoring of up to 4
inputs and switching of 4
outputs
EasyF-I8M Input
module
Monitoring of up to 8
digital inputs
EasyF-ETX Radio
transmitter
Radio limit switch for
mechanical fire dampers
EasyF-RXE
Receiver module
for radio
transmitters
Evaluation and
transmission of the
signals from radio
transmitters
