EasyBus - Signalling and Switching Bus System
Installation, Operating and Maintenance Instructions
Programming of the EasyF modules |
Construction subject to change
No return possible
Version: 2017-11-13 | Page 7
PROGRAMMING OF THE EASYF MODULES
Each EasyF module requires its own address and must be set
to the corresponding channel of the associated master.
For this, a 7-segment display and a programming key are
integrated in each module. They can be used to make
settings.
7-segment display
Programming key
Status indicator of the module:
Module is connected to the EasyBus network
Then the following indications are displayed on the 7-
segment display (factory settings) (A 000; C 01)
Programming the module:
The procedure shows, by way of example, how to change the
address from 001 to 005.
EasyF module is in function
Hold down the programming key >3s
flashes three times
"
appears
Hold down the programming key >3s
appears (flash frequency of the point 3x)
Set the desired number by pressing the key, if
required
Hold down the programming key >3s
appears (flash frequency of the point 2x)
Set the desired number by pressing the key, if
required
Hold down the programming key >3s
"
appears (flash frequency of the point 1x)
Set the desired number by pressing the key, if
required
Press the programming key until a "
is displayed
Hold down the programming key >3s
"
flashes
"
appears (flash frequency of the point 2x)
Set the desired number by pressing the key, if
required
Hold down the programming key >3s
appears (flash frequency of the point 1x)
Hold down the programming key >3s
After that, the address and the channel are visualised and the
programming of this module is completed.
The address and the channel are constantly visualised.
Flash frequency of the point
Place 100 10 1
7-
segment
display
•
•
•
Flash
frequency
3x 2x 1x
