EasyBus - Signalling and Switching Bus System
Installation, Operating and Maintenance Instructions
Programming of EasyS-MV2 |
Construction subject to change
No return possible
Version: 2017-11-13 | Page 13
In the Modbus submenu, briefly press the programming key
to select the submenu items
- "A" (Modbus address)
- „b“ (baud rate)
- "P" (parity)
- "t" (time out)
and hold down the programming key for a long period (>3s)
to display and adjust the corresponding settings. To confirm
the entry, hold down the programming key (>3s) until the
corresponding parameter has been completely set (max. 3
digits). Afterwards, the following submenu items "b", "P" and
"t" and their specific settings must be confirmed by holding
down the programming key (>3s). After that, the 7-segment
display goes out, the master restarts and switches to the
status display.
Place 100
10 1
7-
segment
display
•
•
•
Flash
frequency
3x 2x 1x
Example of procedure for changing the Modbus address from
001 to 005
Master is in function
Hold down the programming key >3s
flashes
Press the programming key until
appears
Hold down the programming key >3s
appears
Hold down the programming key >3s
appears (flash frequency of the point 3x)
Hold down the programming key >3s
appears (flash frequency of the point 2x)
Hold down the programming key >3s
appears (flash frequency of the point 1x)
Press the programming key until a
is displayed
Hold down the programming key >3s
flashes
If no further changes to other submenu items must be carried
out, the programming can be finished at this point. After a
few seconds, the master will switch to the status display, the
change has been applied.
If changes must be also made to the submenus "b" (baud
rate), "P" (parity) and "t" (time out), they can be carried out
analogous to the Modbus address change.
Submenu Factory
setting
Number
of digits
Possible
values
Explanation
001 3
001 to
247
2 1
1 9600
baud
2 19200
baud
3 38400
baud
4 57600
baud
5 115200
baud
2 1
1 None
2 Even
3 Odd
01 2
01 to 99
*10s
