SBS AT10.1 SERIES, Operating And Service Instructions

Page: 10 / 104

INSTALLING THE AT10.1
4
1.5.1. Wall-Mounting the AT10.1
Wall-mounting is the standard means of installing the AT10.1 Style-5017
enclosure. When wall-mounting the AT10.1, consider the following:
1. Refer to the outline drawing (
JE5025-00
) in Appendix C on page 72 for the
overall footprint of the Style-5017 enclosure.
2. The wall must be strong enough to properly support the weight of the
AT10.1, plus a safety factor. See the Weight Table featured in Section 1.4
on page 3. The weight of your AT10.1 may be different, depending on the
feature, options, and accessories ordered with the unit.
3. Be conscious of planned ac input and dc output wiring to the AT10.1,
selecting conduit entrances carefully. Note the standard pre-fab conduit
knockouts located on the sides of the enclosures.
4. The location:
•
Should be free of drips and splatter. If falling particles and liquids are a
problem, install NEMA-2 type drip shield accessory (
EI0191-01 ). For
kit availability, see ordering information in Appendix B on page 71.
•
Should be between 0 and 122 °F / -18 and 50 °C, with relative humidity
between 5% and 95% non-condensing.
•
Must be free of flammable or explosive materials.
5. Maintain at least 6in / 152mm of free air on all vented surfaces for cooling.
6. Allow at least 36in / 914mm front clearance for access to the AT10.1 for
operation and maintenance.
NOTICE
If you need to wall-mount the AT10.1, housed in a Style-5018 enclosure,
a wall-mounting bracket accessory (
EI5008-00 ) is required. For kit
availability see ordering information in Appendix B on page 71. The kit
includes two (2) mounting brackets, special hardware, and
Installation
Instructions (
JA5063-00
) for the wall-mounting procedure.