Savin IS300e, Operating Instructions Manual

Page: 187 / 224

Troubleshooting
179
11
This machine does not work in ac-
cordance with the scan settings
configured on the Web Status
Monitor. • After configuring the scan settings (specifically, after
clicking [ OK ] on the [ Scan Settings ] screen) on the Web
Status Monitor, press the
{{{{
Clear Modes
}}}}
key. By press-
ing the
{{{{
Clear Modes
}}}}
key, the settings under
[ Scan Set-
tings ] of this machine instantly reflect the settings
configured using the Web Status Monitor.
Some of the registered destina-
tions are not displayed on the des-
tination list. • Check if [ All ] is displayed at the top right corner of the
“ Select destination(s). ” screen.
If another title like [ A ] , [ B ] or [ Freq. ] is on the screen, it
means that you have searched destinations using the
{{{{
./*
}}}}
(Title) key, and only the matched destinations are
currently available for selection. In this case, press the
{{{{
./*
}}}}
(Title) key, highlight
[ All ]
, and then press
[ OK ]
. See
p.129 “To recall all available destinations” for details.
The e-mail destinations (including
Cc destinations) are cleared when
a file name is specified. When you perform a Send Scan operation, note the follow-
ing things.
• You cannot use the following functions at the same
time:
• Scan to E-mail (referred to as “e-mail function”
here)
• Scan to Folder (SMB) (referred to as “SMB function”
here)
• Scan to FTP (referred to as “FTP function” here)
When you select
[ File Name ]
and then press
[ Settings ]
on
the screen shown above, it means that you select either
of the SMB or FTP function, and the e-mail function is
disabled. Because of this, the e-mail destinations are
cleared automatically.lSpecifying
[ To: ] , [ Cc&co-
lon; ] , or [ Subject ] disables the SMB or FTP function.
Specifying [ SMB ] disables the e-mail and FTP function.
Specifying [ FTP ] disables the e-mail and SMB function.
Problem Possible Cause and Required Action