13. Glue the back wing skin to the wings. Use
some sort of weight to push the wing skins
down onto the ribs. Make sure the trailing edge
is straight. Make any adjustments before the
glue dries. (Photo 13)
14. Once the glue is dry, remove the wings from
the building board and cut the building tabs
from the tops of the wing ribs and sand the top
of the ribs smooth. (Photo 14)
15. Cut from their sheets two SM1, two SM2 and
four SM3. Drill a small hole in each SM3 for
your servo mounting screws. Run the servo
mounting screws in and out of the holes to cut
‘threads’ in the wood. This will make it easier
to mount the servos later.
Glue these together to form the servo mounts.
Make sure to make a right and left set. (Photo
15)
Photo 13
Photo 14
Photo 15
6
Savage Light Industries
F-106 Delta Dart
