SATO iGT400 Series, Instruction Manual

Page: 57 / 102

Assume the printing will be performed as shown in the figure
on the right, with the base point away from the print reference
point by
vert40 dots (5 mm), and
horizo 80 dots (10 mm)
in GT408.
【
Let’s set
】
“+” of H (horizontal) is highlighted.
●
Each time you press the / buttons, “+” and “–” are
changed over.
● Press the button, and the cursor moves to the figure of V
(vertical).
●
Press the button, and the cursor moves to the figure of H
(horizontal).
● Press the button to register the setting.
V
：
+ 0000 H
：
+ 0000
PRINT OFFSET
● Each time you press the button, the figure is increased by 1.
● Press the button, and the cursor moves to “+” of V (vertical).
● Press the button, and the cursor moves to “+” of H
(horizontal).
● Press the button to register the setting.
ENTER
ENTER
● Each time you press the / buttons, “+” and “–” are
changed over.
●
Press the button, and the cursor moves to the figure of H
(horizontal).
● Press the button, and the cursor moves to the figure of V
(vertical).
●
Press the button to register the setting.
V
：
+ 0000 H
：
+0000
PRINT OFFSET
V
：
+ 0000 H
：
+ 0000
PRINT OFFSET
Setting V (vertical) moving direction
1
When the “Print position correction” screen is shown on the
display, the cursor is on “+” of V (vertical), and highlighted.
Setting moving dot number of V (vertical)
2
The figure of V (vertical) is highlighted.
Setting H (horizontal) moving direction
3
● Each time you press the button, the figure is increased by 1.
●
Press the button, and the cursor moves to “+” of H
(horizontal).
● Press the button, and the cursor moves to “+” of V (vertical).
● Press the button to register the setting. ENTER
The figure of H (horizontal) with the cursor is highlighted.
Setting moving dot number of H (horizontal)
4
PRINT OFFSET
V
：
+ 0000 H
：
+0000
ENTER
Horizontal (H) direction
80 dots (10 mm)
Base point
Print
direction
Print reference
position
Vertical (V) direction
40 dots (5 mm)
52
サトー取説_E 04.8.17 6:22 PM ページ 52